When your hydraulic lines start weeping or you spot a crack in the outer covering, it’s time for a replacement before that slow leak becomes a geyser in the middle of harvest. This 48-inch hydraulic hose assembly gives you a ready-to-install solution with male rigid ends that’ll get your equipment back to full pressure and keep you moving.
What You’re Getting
- 2-wire construction handles medium-pressure hydraulic systems found on most farm equipment
- Male rigid NPT ends thread directly into your existing hydraulic fittings
- 48-inch length works for most tractor and implement connections
- Pre-assembled and pressure tested so you know it’ll hold when you need it to
- AgSmart quality built to handle the pressure cycles and temperature swings of farm work
Built for Real Farm Work
This hose assembly fits right into the hydraulic systems on tractors, loaders, and implements where you need reliable medium-pressure flow. Whether you’re running a bucket, operating a three-point hitch, or powering remote hydraulics on your implements, this 3/8-inch size handles the flow requirements for most auxiliary hydraulic functions.
Made to Last
The 2-wire reinforcement gives you the strength to handle working pressures up to typical farm hydraulic system specs. The outer covering resists abrasion from rubbing against brackets and guards, while the inner tube stands up to hydraulic fluid and temperature changes from cold morning starts to hot afternoon work.
Installation Notes
These rigid ends thread right into standard NPT fittings – just make sure to use proper thread sealant, not tape that can break loose and contaminate your system. Check that both ends are the right thread size for your application before installation, and route the hose away from sharp edges or hot exhaust components.
